Polycom KIRK 14117800, Installation And Configuration Manual

Page: 111 / 220

Configuring KIRK Wireless Server 600v3 111
KIRK Wireless Server 600v3 Installation and Configuration Guide
7.6.4.2 Assigning a Specific IP Address
(Secondary)
To assign a specific IP address to the KWS600v3, it is necessary to disable the DCHP
mode and then assign a specific IP address to the KWS600v3. The new IP address and
network address will be provided by the system administrator.
Note:
It is advisable that the IP addresses for KWS600v3 secondaries are numbered in
succession; eg. 192.168.1. 3 , 192.168.1. 4 , 192.168.1. 5 etc. This makes it easier to detect a
specific Secondary KWS600v3.
1
Under the Configuration menu, click ETH0 , and then click DHCP .
Figure 51
Adm. Page: Configuration/ETH0/DHCP page
2
From the Mode list, select Disabled , and then click OK .
3
Click Reset (under Administration menu) to save your configuration.
4
Under the Configuration menu, click ETH0 , and then click IP .
Note:
It is necessary to use the ETH0 port when integrating the KWS600v3 on the
local network.
Figure 52
Adm. Page: Configuration/ETH0/IP page