Polon-Alfa Ignis 1000, Operation And Maintenance Documentation

Page: 11 / 45

ID-E299-001GB 11
(21) FUNCTION SW.OVER , (22) SELECTION , (23) SET – three push buttons enabling usage of the
functions designated for the control panel parameters readout or change at the 2
nd
access level:
•
FUNCTION – a function selection,
•
SELECTION -
moving the cursor to the right,
•
SET - setting change.
4.2.2 Handling elements inside the control panel
Fig. 5 depicts the handling elements mounted on the STR-1240 controller board located inside the
control panel:
(P1) FUNCTION , (P2) SELECTION , (P3) SET↑ and (P4) SET↓ – four push buttons inside the control
panel that enable usage of the functions dedicated to the control panel programming;
(P13)
RESET
- the control panel controller restart.
Table 4
Jumper No. Jumper position Function
ZW1
1-2 Support of 16 detection lines – two line modules
2-3 Support of 24 detection lines – three line modules
ZW2
1-2 Unused
2-3 Unused
ZW3
1-2
2-3
ZW4
÷
ZW10
Unused
ZW11
1-2
2-3 Service mode without alarm receipt delays
ZW12
1-2
2-3 Software version display after pressing ACKNOWLEDGEMENT
push button
Fig. 6 presents the view of the MZ-4212 power supply unit module that contains:
WŁ. AKU push button - used for switching the control panel on at the mains supply outage
(essential when the batteries connection does not cause the control panel self-activation);
ZW1
jumper - enables disconnection the earth fault monitoring circuit and anti-interference
modules from the casing;
ZW2 - a jumper enabling the earth fault monitoring circuit switch on/off; when the jumper is set
in the position marked on the board - the earth fault monitoring circuit is switched on;