Polon-Alfa Ignis 1000, Operation And Maintenance Documentation

Page: 15 / 45

ID-E299-001GB 15
CONFIG.SET. FAULT
Disruption in configuration settings saved in
control panel memory
CH. L 1 FAULT Fault in detection line 1 circuit
CH. L 2 FAULT Fault in detection line 2 circuit
CH. L 3 FAULT Fault in detection line 3 circuit
SDL 1 FAULT Fault in alarm signalling devices line 1 circuit
SDL 2 FAULT Fault in alarm signalling devices line 2 circuit
SDL 3 FAULT Fault in alarm signalling devices line 3 circuit
BREAK OF LINE 1 Break in detection line 1 circuit
BREAK OF LINE 2 Break in detection line 2 circuit
.
.
. .
.
.
BREAK OF LINE 24 Break in detection line 24 circuit
SHORT OF LINE 1 Short circuit in detection line 1 circuit
SHORT OF LINE 2 Short circuit in detection line 2 circuit
.
.
. .
.
.
SHORT OF LINE 24 Short circuit in detection line 24 circuit
LACK OF FAULTS No fault detected in IGNIS system
5.2.5 Disablement/re-enablement of all zones simultaneously
X – no changes
1 – zones enabled
0 – all zones disabled
ZONES ON OFF - X
Note:
Disablement or re-enablement of all zones takes place after typing 0/1 and the control panel restart
using the RESTART push button inside the device.
5.2.6 Alarm counter readout
In order to read the alarm counter out, it is necessary to select with the FUNCTION push button the
following indication on the display (the pictures illustrate the counter exemplary indication):
0001 z2 07 – 09 - 31