POLMAR Shark2, User Manual

Page: 94 / 108

94
6.9 dsc setup
The submenu is used to set behavior of the DSC/ATIS function.
The following 6 items are available for selection.
user mmsI
Group setup
ATIs mmsI
ATIs ENAblE
INdIv REPly
dsc ENAblE
POs REPly
AuTO sWITcH
TEsT REPly
TImE OuT
6.9.1 Enter your user mmsI (user mmIs)
This is a once-only operation.
You must enter your user MMSI first then you can access the DSC functions.
Select DSC SETUP then USER MMSI and press the CH knob. If an existing
MMSI is stored, the values appear.
1. If the MMSI is blank, a dashes line appear. Enter user MMSI along the
dashed line. Press the CH knob to confirm each correct entry to move to
the next digit.
2. If your make an error, press +/- key or rotate CH knob. < appears, then
press the CH knob to backup and correct the entry.
3. Hold the CH knob to store your user MMSI.
4. Enter your user MMSI again as a password check, hold the CH knob to
permanently store the your user MMSI and return to the menu.
5. You can view your stored user MMSI at anytime by selecting user MMSI in
the DSC SETUP menu.
6. If there is no USER MMSI stored and the radio’s DSC function is attempt -
ed, the radio says “PLEASE INPUT USER MMSI” as below.
dsc WARNING mEssAGE
INPuT usER
mmsI
> _ _ _ _ _ _ _ _
usER mmsI
INPuT AGAIN
> _ _ _ _ _ _ _ _
usER mmsI
500000001
> sTORE
cANcEl
PlEAsE INPuT
usER mmsI