FINAL DRIVE
7.10
CONCENTRIC SWINGARM REAR AXLE ASSEMBLY
1.
Install stop ring in groove on left side of axle.
NOTE:
Left side of axle is identified by the small
groove in the middle of the spline.
2.
Install disc hub assembly on axle. Be sure hub
covers stop ring. Install disc in soft jawed vise.
Apply Never Seize to threads, install left axle nut
and tighten to 120 ft. lbs (166 Nm).
Keep
tightening nut until flat aligns with flat on brake
hub.
3.
Lubricate spacer and new O-ring. Install on axle.
Stop Ring
Disc Hub
Groove in spline
Stop ring
Axle Nut (Disc Side) Torque:
120 ft. lbs.
(166 Nm)
Summary of Contents for TRAIL BOSS 325 2001
