Plymovent MultiDust BANK 2F, User Manual

Page: 6 / 52

0000100519/121212/0 MDB-2X/2F/4F
EN - 5
0
Data sheet and general instructions
Transport and erection
- Instruct all persons whose presence is not required to stay
out of the hazard area
- Do not stand under or next to the load when it is being lifted
up or set down
- Transport the unit or erection components on the pallets
provided, and secure them against falling over or slipping.
- Transport them with a suitable pallet truck or forklift truck
(min. lifting capacity 2000 kg)
- The filter unit can be lifted via the support frame connection
(pos. H) with a forklift truck. Care must be exercised, since
the centre of gravity lies in the upper half of the unit
- Filter units must be secured to the foundations
- The foundations must have adequate load-bearing strength
and be free of vibration
Malfunctions and emergencies
affecting the filter unit
Fire - In the event of fire, an approved extinguisher for fire classes
A, B and C should be used
- The manufacturer must be contacted
Escape of noxious substances
or radiation
- The MultiDust Bank contains no noxious substances.
- If the filter ruptures, welding fumes can be released into the
building; welding activities must be suspended and the
MultiDust Bank repaired
Dismantling and disposal - Only a qualified electrician may disconnect the machine or
the electrical system
- Before dismantling it the machine must be disconnected from
the power supply and from the external compressed air
supply
- Before dismantling it, clean the equipment
- The dismantling area must be cleaned afterwards
- During dismantling work, the working area must be
adequately ventilated; this can be achieved by provision of a
mobile ventilation unit
- During dismantling work, wear appropriate personal
protective equipment. We recommend half-face breathing
masks to DIN EN 141/143, protection class P3
- The pollutants and dust, together with the dirty filter
cartridges, must be properly disposed of in a professional
manner in accordance with statutory instructions, using the
plastic sack disposal system supplied
Extraction heads Fixing and extraction volume - Extraction head(s) should be connected to the filter inlet by
means of duct work
- The minimum volumetric airflow of the filter is determined by
the characteristics of the extraction heads; refer to the
manufacturer’s data or obtain the manufacturer’s approval
Positioning the extraction
head
For optimum extraction of welding fumes, the extraction head
should be positioned to collect the welding fumes as they move
upwards under the influence of thermal effects