Plustek NVR Slim380Pro, User Manual

Page: 45 / 57

41
Chapter IV. Technical Guides
This chapter covers plenty of useful technical information on using the NVR, which will
help you get more familiar with this network device. For further information about
networks, you may read their definition or explanation in the
1
Appendix A: Glossary
section of this guide.
LED Indicators
10
The LED indicators at the front of the NVR indicate the status of the NVR, as
described below:
Activity Status LED HDD1 LED Buzzer
System power on Light off Light off One beep sound
System ready, HDD
OK
Consistent light on Consistent light on One 1 ‐ sec beep sound
System ready, no
HDD
Consistent light on Consistent blinking One 1 ‐ sec beep sound every 10
seconds
System ready, HDD
not formatted
Consistent light on Consistent blinking One 3 ‐ beep sound
HDD formatting
(local or remote)
Consistent light ‐ on Consistent blinking
until process done
One 2 ‐ beep sound
HDD ready Consistent light ‐ on Consistent light ‐ on
Camera searching &
adding (only local)
Consistent blinking
during process;
consistent light ‐ on
when process done
Consistent light ‐ on One 2 ‐ beep sound when process
done
HDD format failure Consistent light ‐ on Consistent blinking One 3 ‐ beep sound every 10
seconds
HDD recording Consistent light ‐ on Consistent blinking
HDD read/write
failure
Consistent blinking Consistent blinking One 3 ‐ beep sound every 10
seconds
USB flash drive
detected
Consistent blinking
when USB
detected
Consistent light ‐ on One 0.5 ‐ sec beep sound when
USB detected
USB flash drive write Consistent
blinking; consistent
light ‐ on when
process done
Consistent light ‐ on One 2 ‐ beep sound when done
USB flash drive write
failure
Consistent light ‐ on Consistent light ‐ on Three 3 ‐ beep sound for 3
seconds
10
This function may or may not be available depending on the NVR model you purchase.