E-24
Note
Press the ON/Standby
button and switch on the power.
• When turning on the power, wait about 5 seconds after connecting the
copyboard's AC power plug to the wall power outlet or after turning off the
power (standby mode) before pressing the ON/Standby
button.
• Press the ON/Standby button to switch on the power. The LED of the
display window will light.
Insert the USB memory device into the Memory
port
(USB port) of the copyboard
Using USB Memory
The content of what has been drawn on the sheet surface of the copyboard can be saved in USB memory.
Later, the saved image can be read into a personal computer and made into a document of the proceedings of
the meeting, or affixed to a document.
• What is needed to use the USB memory function
USB memory: Commercially-available product
Personal computer: The connector is a USB port (type A), and the interface supports USB 1.1
• The copyboard supports the USB memory formats of FAT and FAT 32.
• The factory default for the resolution of images when storing them on USB memory devices is "Standard". There are
two ways to switch this to a high resolution: by changing the copyboard's function Settings (see page E-29), or by set-
ting "Resolution" in TOOLBOX to "High Resolution". (For instructions on operating TOOLBOX, see the separate "Software
Operation Manual".)
• More time is required for storing images when the resolution is set to high.
USB Memory Storage Procedure
• Check the side (polarity) of the USB memo-
ry device before inserting it. Forcing it in the
reverse orientation will damage the USB port
or USB memory device.
• Be careful not to bump into the USB memory
device with hand or body while it is mounted.
Doing so could damage the USB memory
device or USB port.
Press the Feed/Stop
button (for model M-125, the Page
change
/
buttons) and display the sheet surface you want
to store.
M-12S/M-12W
M-125
Notice
•
For a description of the USB memory devices usable with this copyboard, please go to our website at:
h t t p : / / w w w. p l u s - v i s i o n . c o m
Preparation:
Check that the copyboard's AC power plug is connected to a wall power outlet.
See page E-15.
Note
Notice
For models M-12S and M-12W
For model M-125
