Plum ecoMAX 80 R1, Instruction Manual

Page: 10 / 51

10
Specify the preset boiler temperature by
entering:
MENU -> Preset CH temp.
and setting this parameter at the desired
value.
The preset boiler temperature can be also set
at the main window.
Press the “
TOUCH and
PLAY
” knob in the main wi
ndow and turn it to
specify the preset boiler temperature
–
the
temperature “pulsates”.
Confirm the settings
by pressing the “TOUCH and PLAY” knob
once more. In order to exit the temperature
editing, press the EXIT button.
The regulator skips the preset CH temp.
parameter when the preset boiler
temperature is determined in relation to the
weather. The preset boiler temperature is
temporarily increased in order to fill the
domestic hot water tank, and the mixer
cycles.
8.5 STOP
After its activation, the regulator is in the
STOP mode. The STOP mode can be also
enabled by selecting the STOP operation
mode in the main window and pressing the
„TOUCH and PLAY” knob.
Drawing 4 View of the main window in the STOP mode
In this mode, the following executive devices
are disabled: blower, feeder, - CH pump and
DHW pump. The mixer (pump and servo)
stays active.
In the STOP mode, the CH pump is
turned off, which can increase the
boiler temperature.
8.6 FIRING UP
Enter the LIGHT mode by selecting the
LIGHT operation mode and pressing the
“TOUCH and PLAY” button.
The LIGHT mode is used to fire up the
furnace in the boiler In this mode, the user
can manually control the airflow and the fuel
feeder. The boiler should be fired up in strict
accordance with the boiler manufact
urer’s
recommendations.
Drawing 5 Manual start-up of the feeder
Pressing the „
TOUCH and PLAY
” knob on the
feeder symbol activates it, which is signalled
by an ON sign next to this symbol. Feed the
fuel until it appears at the end of the retort.
Press the knob again to turn the feeder off.
Next, put some kindling (e.g. for barbecue)
under the layer of fuel and light it.
Drawing 6 Disabling the feeder during firing up
Pressing the “
TOUCH and PLAY
” knob
on the
airflow symbol activates it, which is signalled
by an ON sign next to this symbol. Press the
“
TOUCH and PLAY
” knob again to turn the
airflow off. Light the fed fuel up and, once in
a while, feed another dose of the fuel.
Pressing EXIT when the parameter
- e.g. the preset boiler temperature
-
„pulsates” makes the regulator
discard the specified value. To
make the regulator store the preset
value, confirm it by pressing the
“
TOUCH and PLAY
” knob.