Replacement
Adjustment
20 September 2006, Rev 0.01
3-27
3.4.13 SIDE JOGGER DRIVE
ASSEMBLIES
Removal
1. Remove in-feed module (
3.4.1 ).
2. Remove side jogger motor M4 (
3.6.4 )
3. Remove tension pulley [A].
4. Remove screw for timing belt [B] ( x1 ).
5. Loosen two screws [C] at the end of the side jogger shaft and lift out the jog-
ger assembly ( x2 ).
Installation
1. Reverse the removal procedure
Adjustment
1. When tightening the screws [C] make sure that the shaft is mounted at the end
of the slots ( x2 ).
2. Check that both side jogger channel mounting brackets [D] are centred in the
machine. Move the side jogger channel brackets all the way out. They should
touch the right and the left frame at the same time.
3. If not loosen the two screws [E] for the belt clamp bracket and move both jogger
channel brackets until they stops against the frames. Tighten the screws [E] ( x2 ).
[B]
[D]
[D]
[E]
[C]
[A]