20 September 2006, Rev 0.01
3-10
COVERS
3.3.6 PAPER PATH
Removal
1. Remove trimmer unit if any (
1.4.4).
2. Set the machine to A4 portrait – edge stapling.
3. Open top cover.
4. Move the side jogger channels [A] to the widest position.
5. Unhook the spring [B].
6. Note the position of the balls in the ball cage [C] in the pre-fold ASSEMBLIES-
nd remove them.
7. Install the interlock cheater.
8. Enter service mode, solenoids.
9. Activate SOL4. It will be deactivated automatically after one minute.
10. Move the left paper guide [D] so the screw [E] can be reached by holding the
stop gate [F] down while moving the left paper guide [D] out ( x1 ).
11. Remove the screws [G] ( x6 ) along the paper path and the screw [E] ( x1 ).
12. Activate SOL4 again.
13. Lift up the paper path and slide it towards the fold area. Push down the stop
gate and continue to slide the paper path out through the fold area.
Installation
1. Reverse the removal procedure.
[A]
[B]
[C]
[C]
[D]
[E]
[F]
[G]
[G]
[G]
[G]
[G]
[G]
CAUTION
Tighten the screws with matched screwdriver so no burrs will arise on the
screw heads. Reinstall the balls in the right order and the spring.
