20 September 2006, Rev 0.01
3-18
The stapler head drive post on each stapler head should be lubricated every 20 00
cycles.
1. Put a couple of drops of oil [G] on each side of the drive post [H].
2. Cycle the stapler head a few times before installing it again.
[G]
[H]
[G]
ASSEMBLIES
3.4.6 STAPLER CARTRIDGE AND STAPLER HEAD, CONTINUES
Note:
When a stapler head is removed, be sure to manually eject some staples
before replacing it in the BM 2000. To do this, rest the stapler head on a
firm surface (for example, the top of a table) and actuate the staple driver
post up/down through full travel. Do this a number of times to ensure that
the staples are ejected on each down movement. If you need to change
the staple cartridge, see previous section, removal/replacement of staple
cartridge.
WARNING
When manually ejecting the stapler, stay clear from stapler output area.
Maintenance
WARNING
When manually ejecting the stapler, stay clear from stapler output area.
