Plextor 241040 ATAPI, Operation Manual

Page: 9 / 72

Section 1. Getting Started
PlexWriter 24/10/40A Operations Manual
5
Rear Panel
Figure 2: Rear Panel of the PlexWriter 24/10/40A Internal Drive
•
DMA jumper: Use to converts between Ultra DMA Mode-2 (no jumper, default)
and DMA Mode-2 (with jumper installed).
•
Digital audio output connector: Outputs digital stereo signal. For connecting to
a sound board that supports Sony/Philips digital interface (SPDIF) or Digital_In.
•
Analog audio output connector: Outputs analog stereo signal. Use to connect to
sound board or audio amplifier. Use standard MPC-3 type, 4-pin connector.
•
Mode jumper: Use to select operation as an IDE master or slave, or for cable
select. In general, leave this jumper at its factory setting.
•
IDE cable connector: Connects to IDE interface using 40-pin IDE flat ribbon
cable.
•
Power connector: Connects to your computer’s power supply to provide
DC +5 volts and +12 volts to the PlexWriter.