Copyright Planika Sp. z o.o.
www.planikafires.com
IG0058#00
31.03.2017
7
3.1.
Safety instructions
•
WARNING!
The device is powered by a voltage of 230 V AC, 50 Hz
•
VALENTINO fireplaces are not standalone devices and are intended only for installation.
•
Co najmniej raz w roku należy zlecać przegląd konserwacyjny urządzenia. At least once a year you should make
an overview of the device maintenance.
•
Always observe the minimum distances between combustible walls of the housing and the device.
•
Combustible materials should be placed no closer than within 1 m from the unit.
•
Only decorative accessories attached to the device by the manufacturer should be placed on the furnace (logs,
stones, vermiculite or ash imitation). These accessories should be installed as described in this manual.
Incorrect placement of decorative materials may result in shortening the useful life of the furnace and its
damage.
•
WARNING! Make sure you don’t place any decorative elements around the ignition and ionization electrodes.
•
Before the final installation and before starting to construct the fireplace housing, make sure that blast-
resistant flaps at the top of the device are in correct position and whether they were properly attached to the
sealing surface.
•
If the ignition of the device is incorrect or the Fireplace will fail, you should close the gas valve and contact the
installer and make sure that the device is not energized.
•
If there is no ignition of the device after three restarts and permanent lock of the device activates, reset by
disconnecting from the power source may be impossible. In such cases, please contact your distributor or
installer.
•
In the event of damage or break the glass, the device cannot be used and you must close the gas valve and
immediately request glass
•
The remote control should be kept out of reach of children and unauthorized persons not familiar with the
unit's User Manual.
•
If the device is not used for an extended period of time, close the gas valve and remove the batteries from the
remote control. This will prevent damage due to battery leakage.
•
It may happen that the device will turn off automatically and immediately turns on. This is not a failure, but
test procedure resulting from the design and configuration of the driver, because the control device is subject
to strict safety requirements. From the moment you connect a device driver to a power source, the driver will
perform this test every 24 hours. If the device is currently lit, it goes off and immediately turns on again.
WARNING!
Operate the device using the remote control with use of the built-in thermostat or (optional) tablet
with a special application or home automation system, the device can turn on when you are not at home.
Therefore, in such cases, you should take extra precautions before switching on the machine without
supervision (eg. an additional switch of electricity on the power cord; closing the ball valve on the gas supply
line to the device) in order to avoid damage to objects or injuries and the use of to all safety instructions in
this manual.
