Copyright Planika Sp. z o.o.
www.planikafires.com
IG0058#00
31.03.2017
21
8.1.2.
Flame height adjustment
To change the height of the flame, you must press once button
or
on
the remote control. You should see on the screen flashing, currently set value
of the flame height. Set the required flame height by using the buttons
or
. Depending on which button is pressed, the symbol
or
will be
briefly visible on the screen. Flame height can be set as a numeric value in the
range from 1 (the lowest flame) to 15 (highest flame). By default, the device is
started at the highest flame level that can only be adjusted when the machine is turned on. You can go back to the
main screen by pressing the button
or wait five seconds after pressing the last key.
8.1.3.
Temperature regulation
To control the device through manual adjustment of the desired temperature in the room, proper configuration in the
user menu (Section 6.4) will be necessary. The device will then turn on and off automatically depending on the
manually set temperature and heat demand. If the room temperature is approaching the temperature set by the user,
driver of the device will automatically reduce the height of the flame. If the temperature exceeds the temperature set
by the user, the device driver will automatically turn off the fireplace and start it again if the room temperature drops
below the temperature set by the user.
To change the desired temperature, press once
or
button on the remote
control. The display shows currently set flasing temperature. Set the required
temperature by using the buttons
or
. Depending on which button is
pressed, the symbol
or
will be briefly visible on the screen. Temperature
can be set as a value in the range from 5,0 °C to 35,0 °C.
WARNING!
The remote control is equipped with a thermostat and must be in the same room as the unit. Place it
always in the same place, free from drafts, and do not expose it to direct sunlight and heat radiating from the fireplace.
Back to the main screen can be done by pressing the button
or after waiting five seconds of pressing last button.
