Copyright Planika Sp. z o.o.
www.planikafires.com
IG0058#00
31.03.2017
12
•
Press and hold the button
on the remote control for 10 seconds.
•
Then press for a short time the same button several times until screen „1”
appears.
•
Briefly press buttons
and
at the same time until screen 2 appears. After a successful completion of
the process of setting up the communication, startup screen will be displayed.
If the connection fails, screen 1 will appear again.
Setting a new communication code is required after each battery replacement or after
a
power failure for more than 5 minutes.
WARNING!
It cannot be ruled out, although it is unlikely that the ignition of the device can be started unintentionally
by other remote controls (for example, remote control of another gas heater, car remote control or remote control
for garage doors working in the 868 MHz band). As a result, the device can be ignited at the wrong time, also during
our absence. In the event of such situation, you must take the following preventive measures:
•
establish a new communication code between the remote control and the receiver (if accidental ignition took
place).
•
Close the gas valve near the device, if the device will not be used for an extended period of time. This is the
safest remedy.
•
Change the position of the receiver to minimize the possibility of receiving unwanted radio signals.
•
Follow the specific instructions of the security measures, even if the device is not in use.
5.3.1.
Battery exchange
Before using the remote control you must place the two supplied batteries (type AA). After inserting the batteries and
after connection to receiver, the remote control is ready to operate the fireplace by manual adjustment of the flame
height. To extend battery life, after some time the button was last pressed, the screen goes blank, unless the device is
turned on.
If the display shows the flashing symbol
, replace the batteries. If the batteries are completely discharged, the
display goes off. Therefore, you should replace the batteries in the remote control. To change it, you should:
•
Remove the back cover of the remote control by moving it a few millimeters down (Picture 2, Part 1) and lifting
it to the top.
•
Remove the old batteries from the housing.
•
Place the new battery pack in the housing (Picture 2, Part 2).
•
Mount the back cover of the remote control, placing the tabs A and B of the rear cover (Picture 2, Part 3) in
the corresponding notches of the remote control housing (Picture 2, Part 2).
