Planet NAS-5400, User Manual

Page: 2 / 152

Safety Approvals
u
CE Marking
u
FCC Class A
FCC Compliance
This equipment has been tested and complies with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. If not installed and used in accordance with proper
instructions, this equipment might generate or radiate radio frequency energy and cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measurers:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with emission limits.
Safety Precautions
Before getting started, read the following important cautions.
1.
Be sure to ground yourself to prevent static charge when installing the internal components.
Use a grounding wrist strap and place all electronic components in any static-shielded devices.
Most electronic components are sensitive to static electrical charge.
2.
Disconnect the power cords from the NAS server before making any installation. Be sure both
the system and the external devices are turned OFF. Sudden surge of power could ruin
sensitive components. Make sure the NAS server is properly grounded.
3.
Do not open the system
’
s top cover. If opening the cover for maintenance is a must, only a
trained technician is allowed to do so. Integrated circuits on computer boards are sensitive to
static electricity. To avoid damaging chips from electrostatic discharge, observe the following
precautions:
ü
Before handling a board or integrated circuit, touch an unpainted portion of the system unit chassis for a few
seconds. This will help to discharge any static electricity on your body.
ü
When handling boards and components, wear a wrist-grounding strap, available from most electronic
component stores.
Copyright
Copyright

2004 by PLANET Technology Corp. All rights reserved. No part of this publication
may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any
language or computer language, in any form or by any means, electronic, mechanical, magnetic,
optical, chemical, manual or otherwise, without the prior written permission of PLANET.
PLANET makes no representations or warranties, either expressed or implied, with respect to