12
| Installing the Board and Driver in a PC
To install multiple boards
Repeat the installation instructions in “Preparing for Board
Installation” on page 8 for each board.
This table lists the number of boards and screens supported by
the Windows NT 4.0 drivers.
Remember these tips when you are installing multiple boards:
• Each board requires less than 3 amps of +5V.
• You can install as many Md2/PCI boards as your computer’s
power supply and available PCI slots can support.
(Windows 2000 only)
• You cannot mix DOME board types in one computer; for
example, you cannot run one Md2/PCI and one Md4/PCI™
board. You can mix single- and dual-headed boards.
(Windows NT only)
• The screens are assigned to the boards in the order in which
the boards are found on the bus. For example, if the first
board is a dual-headed board, it controls screens zero (0)
and one (1). (Windows NT only)
This DOME driver…
For this
operating system… Can support up to…
Version 4.01–4.3.3
Windows NT 4.0
Four boards
(8 screens)
Version 4.4.0 or later
Windows NT 4.0
Eight boards
(16 screens)
