PiXORD 261 series, User Manual

Page: 78 / 83

Note : Any file upload to PIXORD NDC should be set to “binary” mode in FTP utility; otherwise, the
file may be corrupted in PIXORD NDC.
4) Verify updated contents
After uploading the custom pages, open browser to verify the correctness of contents. If not correct, modify the
pages and return to previous step to upload again.
5) Save the changes to flash
Telnet to the PIXORD NDC. And run command “Up –w” to write the complete web pages into flash. The
detailed procedures are list as below,
1. Open DOS window
2. Enter “telnet <IP Address of PIXORD NDC >”
3. Enter “root” and “pass” as username and password
4. Enter “Up –w” to start the web content update program. The command is case sensitive. Don’t
enter the wrong case or you’ll get the command not find error message. After processing about 30
seconds, the PIXORD NDC will restart automatically and complete the web content updating. Now
you can open the browser to see the new web content.
Note : The limitation of overall size of content pages is around 700K Bytes. Any file added/updated plus original
downloaded file (~550K Bytes) should not exceed this size; otherwise, some files will be truncated or
corrupted. If the corruption of any page happens, you will have to reload the original binary (see Appendix A -
Upgrading the Software) in order to recover the corruption.
For example, the PIXORD NDC IP address is 192.168.0.200, then
C:\temp> telnet 192.168.0.200
C:\temp>
Telnet session  Open Telnet session
Login: root
Password:

Enter “ pass ” as default
Welcome to VidSvr on Telnet ...
IVS> Up –w
Upgrade WWW Pages...  Frozen here, close and open browser
After 30 seconds to verify the changes.
78