PiXORD 261 series, User Manual

Page: 67 / 83

Setting Preset Dwell Time
The dwell time means the time user wants to view on certain preset position under Auto Pan the Preset Dwell
Time can be set between 0 ~ 255 seconds. (The factory default is 0 second)
* If the dwell is set to 0 second then that position will be omitted from the Auto Scan Tour.
To set dwell to 5 seconds: Push key 5 followed by F 2 key.
Ex. To set dwell to 5 second: 5 F 2 keys
To set dwell to 10 second: 1 0 F 2 keys
Storing Preset Data
Once the above steps have been completed, the information must be stored or it will not be memorized by the
system.
PIH-801II:
Push key 1 followed by F 3 key, two beeps will be heard confirming that data is stored.
PIH-801:
When PIH-801 is used, there is no need to perform data saving step for 1st ~ 16th preset.
For 17th ~ 128th presets F 3 key should be pushed to store data.
Note: For the first 16 presets on each dome, the above steps must be repeated. For presets
17 ~ 128 there is a default speed and dwell setting so steps 5 and 6 are not required.
Recalling Preset Positions
Once the required preset positions have been stored in a dome, they may be quickly recalled returning the dome to
exact position.
To recall 1st Preset Position: Push key 1 followed by PRESET key.
The dome will move to that position in speed of 360 / sec.
Ex. To recall 1st preset position: 1 PRESET keys
To recall 128th preset position: 1 2 8 PRESET keys
67