PiXORD 261 series, User Manual

Page: 75 / 83

Enter DOS by "start->Program->MS-DOS Prompt"
Change to the directory where the latest flash.bin exist.
Start ftp session by enter “ftp <PIXORD NDC IP Address>
Enter "root" as USERNAME, "pass" as PASSWORD if no user in User List record. In case any user list
exists, you will have to use your administrator's USERNAME and PASSWORD to login
4. Set FTP to binary mode using the command "bin".
In FTP session window, Enter "bin"
5. Upload the software into PIXORD NDC by FTP "put" command.
In FTP session window, enter "put flash.bin"
In FTP session window, enter "bye" to quit FTP session.
6. FTP session may freeze for around 1 minute to transfer and automatically upgrade the software. During that
time, ping the PIXORD NDC until get constant reply, which means system had completed upgrading and
rebooting, then open browser to verify the software version been updated.
Note : If FTP session quits immediately after issued by command, you should continue pinging PIXORD
NDC instantly. If PIXORD NDC replies to the ping command right after pinging, it means PIXORD NDC
may not enter the self-programming stage to verify the software version. If not updated, then you should
reboot PIXORD NDC and back to step 3 to try again
C:\temp> ftp 192.168.0.200
Connected to 192.168.0.200.
220 192.168.0.200 PIXORD FTP server (ARM_BE - V3.0.H) ready.
User (192.168.0.200:(none)): root
331 Password required for root.
Password: <=enter pass as default
230 User root logged in.
ftp> bin
200 Type set to I.
ftp> put flash.bin
200 PORT command successful.
150 Opening BINARY mode data connection for flash.bin
226 Transfer complete.
ftp: 2097152 bytes sent in 10.11Seconds 207.43Kbytes/sec.
ftp> bye
75