6.4.3 Dual Node Relays from Your Unit
When you program a Dual Node Relay programmable AutoDial job, the First
Relay Station (or Node 1)
must be a Model 9000, 9550 or 9750). Use one of the
following methods:
A. Enter a Dual Node Relay programmable AutoDial job.
B. Program a P-Key for a Dual Node Relay routine. Once you have
selected the appropriate P-Key to be programmed, follow the same
procedures as outlined for entering a Dual Node Relay programmable
AutoDial job below. This establishes a regular Relay job that can be
easily repeated by placing a document in the Feeder and pressing the
appropriate P-Key.
C. Follow DTMF dialing procedures. This is commonly referred to as a
Touch Tone and can be accomplished using the Numeric Keypad on
your 9930 Series.
To enter a Dual Node Relay programmable AutoDial job:
124
Do This
1. Insert the document face down in the Document Feeder
and press FUNCTION twice.
2. Press YES.
3. Press 3, then press YES.
4. Press YES for Dual Node Relay. The 9930 cannot be
used as a Relay Station.
5. Enter the NODE 1 Speed Dial number or One Touch
Key followed by YES.
6. If you entered a Speed Dial number, press YES a
second time.
7. Press YES and enter another number by one of the
methods mentioned in Step #5 above. Repeat Steps #5
and #6 until all numbers are entered. Then press NO to
continue.
This Happens
The number appears in the
display.
AUTO DIAL?
ENTER YES OR NO
1=SND 2=RCV 3=RELAY
4=SND/RCV 5=MAILBOX
▼
DUAL NODE RELAY?
ENTER YES OR NO
ENTER NODE 1 STATION #
ANOTHER NUMBER?
ENTER NODE 2 STATION #
Summary of Contents for 9930
Page 2: ...Operator s Guide Model 9930 ...
Page 19: ...3 2 Operator Control Panel 7 ...
