Piranha CNC Plasma Cutting Table, Operating Manual

Page: 141 / 176

APPENDIX A
– FastCAM SETUP
Sept-2018
141
APPENDIX A
– FastCAM SETUP
The Piranha C-series Plasma Table comes standard with a seat of FastCAM
software. This software comes in a plastic case and consists of:
1. A disk containing the FastCAM Software
2. A dongle (this is a device that looks like a USB Flash Drive, but it functions as
a license key to unlock the software. The FastCAM software cannot run
without the dongle in place in the computer’s USB port)
3. Installation and Startup Instructions
The FastCAM license allows the user to run FastCAM on one computer at a time. In
order
to run FastCAM, the dongle must be in place in the computer’s USB port.
NOTE : Do not misplace the dongle. If the dongle is misplaced, a replacement
dongle will be required at the cost of the entire FastCAM software package.