Piranha CNC Plasma Cutting Table, Operating Manual

Page: 44 / 176

INSTALLATION
Sept-2018
44
6. Insert the opposite end of the torch lead (from the cable carrier) into the
front of the Hypertherm Powermax power supply
7. Insert the plug end from the Hypertherm interface cable into the
connection at the top right on the rear panel of the Powermax power
supply.
8. With power to the machine OFF, r
emove one of the 7/8” knockouts on the
side of the electrical cabinet. Run the other end of the grey cable into the
electrical cabinet.
Use a ½” cord grip at the entrance to the cabinet.
9. Inside the electrical cabinet, connect the terminals from the interface
cable to the terminal strip in line with wires 33 through 36. There are
three pairs of wires in the Hypertherm cable: Green/Black; White/Black;
Red/Black
•
Green wire to wire 33; Black wire to wire 34
•
Black wire to wire 35; White wire to wire 36
•
Red / Black wires are not used and each connection should be
separately taped over
with electrician’s tape.
10. Insert a compressed air line into the rear of the Powermax power supply