Additional information
12
116
En
Remote control
During playback of DVD-
Audio, the display shows
PCM
.
• This will occur when playing DVD-Audio material over the HDMI connection.
This is not a malfunction.
The power turns off
automatically and some
indicator flashes, or some
indicator flashes and the
power does not turn on.
• See the
Power
section (page 109).
Symptom
Remedy
Cannot be remote controlled. • Set the remote control unit’s remote control mode so that it matches the
setting on the receiver (see
Operating multiple receivers
on page 78).
• Check whether the receiver’s remote control mode is properly set (see
Remote Control Mode Setup
on page 108).
• Try replacing the batteries in the remote control (see
Loading the batteries
on
page 8).
• Be sure to operate within 7 m and a 30º angle of the remote sensor on the
front panel (see
Operating range of remote control unit
on page 14).
• Check that there are no obstacles between the receiver and the remote
control.
• Make sure that there is no fluorescent or other strong light shining on to the
remote sensor.
• Check the connections of the
CONTROL IN
jacks (see
Operating other Pioneer
components with this unit’s sensor
on page 38).
Other components can’t be
operated with the system
remote.
• If the battery ran down, the preset codes may have been cleared. Re-enter the
preset codes.
• The preset code may be incorrect. Redo the procedure for entering preset
codes.
• When commands from the remote control units of other devices are
registered using the learning function, in some cases they may not be learned
properly. In this case, register the commands again using the learning function
(see
Programming signals from other remote controls
on page 79). If they still do
not work, they may be in a special format that cannot be registered on this
receiver’s remote control. Operate the device using another remote control.
Symptom
Remedy
VSX-1020_FLXCN.book 116 ページ ２０１０年４月１５日 木曜日 午後４時１０分
