Controlling the rest of your system
09
83
En
English
Français
Deutsch
Nederlands
Italiano
Español
5
Repeat steps 3 to 4 to program a
sequence of up to five commands.
Programming mode will terminate
automatically when the 5 commands are
entered.
• If you press
R.SETUP
before programming
is completed, commands programmed up
to that point will be stored.
Using multi operations
1
Press MULTI OPERATION.
The LED flashes continuously.
2
Within five seconds, press an input
function button that has been set up with a
multi operation.
The receiver switches on (if it was in standby)
and the programmed multi operation is
performed automatically.
Using System off
1
Press MULTI OPERATION.
The LED flashes continuously.
2
Within five seconds, press
SOURCE.
The command sequence you programmed
will run, then all Pioneer components will
switch off
1
, followed by this receiver (switch of
all the zones becomes off).
Erasing the settings for the multi-
operation
This erases all the settings programmed in the
remote control for the multi-operation.
1
Press and hold R.SETUP, then press “8”
for three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP
.
2
Press the input function button
containing the program you want to cancel
or the
SOURCE button for three seconds.
If the LED lights for one second, the erasing
has been successfully completed.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes
are sent.
VSX-1020_FLXCN.book 83 ページ ２０１０年４月１５日 木曜日 午後４時１０分
