Basic Setup
04
42
En
3
Select the parameters you want to set.
1
If the speakers are connected using any setup
other than the Front height setup, be sure to
set
Speaker System
before the Auto MCACC
Setup. See
Speaker system setting
on
page 102.
•
Speaker System
2
– Select your speaker
system setting.
•
EQ Type
– This determines how the
frequency balance is adjusted.
•
MCACC
– The six MCACC presets are used
for storing surround sound settings for
different listening positions. Simply choose
an unused preset for now (you can rename
it later in
Data Management
on page 99).
•
THX Speaker
– Select
YES
if you are using
THX speakers (set all speakers to
SMALL
),
otherwise leave it set to
NO
.
4
Press
and then select START.
5
Follow the instructions on-screen.
Make sure the microphone is connected, and if
you’re using a subwoofer, make sure it is
switched on and set to a comfortable volume
level.
6
Wait for the test tones to finish, then
confirm the speaker configuration in the GUI
screen.
A progress report is displayed on-screen while
the receiver outputs test tones to determine the
speakers present in your setup. Try to be as
quiet as possible while it’s doing this.
3
If no operations are performed for 10 seconds
while the speaker configuration check screen
is being displayed, the Auto MCACC Setup will
resume automatically. In this case, you don’t
need to select ‘
OK
’ and press
ENTER
in step 7.
• With error messages (such as
Too much
ambient noise!
or
Check microphone.
),
select
RETRY
after checking for ambient
noise (see
Problems when using the Auto
MCACC Setup
on page 43) and verifying the
mic connection. If there doesn’t seem to be
a problem, you can simply select
GO NEXT
and continue.
The configuration shown on-screen should
reflect the actual speakers you have.
Note
1 • When data measurement is taken, the reverb characteristics data (both before- and after-calibration) that this
receiver had been storing will be overwritten. If you want to save the reverb characteristics data before measuring,
connect a USB memory device to this receiver and transfer the data.
• When measurement is taken of reverb characteristics data other than
SYMMETRY
, the data are not measured after
the correction. If you will need to measure after correcting data, take the measurement using the EQ Professional
menu in the Manual MCACC setup (page 94).
2 If you are planning on bi-amping your front speakers, or setting up a separate speaker system in another room, read
through
Speaker system setting
on page 102 and make sure to connect your speakers as necessary before continuing
to step 4.
RECEIVER
3 Do not adjust the volume during the test tones. This may result in incorrect speaker settings.
Now Analyzing...
2/9
Environment Check
1a.Full Auto MCACC
A/V RECEIVER
Exit
Cancel
Ambient Noise
: OK
Microphone :
Speaker YES/NO
:
L : YES
FHL :
YES
C : YES
FHR :
YES
R : YES
SR :
YES
SBR :
YES
SBL :
YES
SL : YES
SW :
YES
1a.Full Auto MCACC
10
OK
RETRY
A/V RECEIVER
Exit
Cancel
VSX-1020_FLXCN.book 42 ページ ２０１０年４月１５日 木曜日 午後４時１０分
