Additional information
12
112
En
Broadcast stations cannot be
selected automatically, or
there is considerable noise in
radio broadcasts.
For FM broadcasts
• Fully extend the FM wire antenna, adjust the position for best reception and
secure to a wall, etc.
• Use an outdoor antenna for better reception (see page 31).
For AM broadcasts
• Adjust the position and direction of the AM antenna.
• Use an outdoor antenna for better reception (see page 31).
• Noise may be caused by interference from other equipment, such as a
fluorescent light, motor, etc. Switch off or move the other equipment, or move
the AM antenna.
Noise is output when
scanning a DTS CD.
• This is not a malfunction of the receiver. The scan function of your player
alters the digital information, making it unreadable, resulting in noise being
output. Lower the volume when scanning.
When playing a DTS format
LD there is audible noise on
the soundtrack.
• Make sure that the input signal type is set to
DIGITAL
(see
Choosing the input
signal
on page 62).
Can’t record audio.
• You can only make a digital recording from a digital source, and an analog
recording from an analog source.
• For digital sources, make sure that what you’re recording isn’t copy protected.
• Check that the
OUT
jacks are properly connected to the recorders input jacks
(see
Connecting other audio components
on page 30).
Subwoofer output is very low. • To route more signal to the subwoofer, set it to
PLUS
or set the front speakers
to
SMALL
(see
Speaker Setting
on page 103).
Everything seems to be set up
correctly, but the playback
sound is odd.
• The speakers may be out of phase. Check that the positive/negative speaker
terminals on the receiver are matched with the corresponding terminals on the
speakers (see
Connecting the speakers
on page 20).
The
PHASE CONTROL
feature doesn’t seem to have
an audible effect.
• If applicable, check that the lowpass filter switch on your subwoofer is off, or
the lowpass cutoff is set to the highest frequency setting. If there is a
PHASE
setting on your subwoofer, set it to 0º (or depending on the subwoofer, the
setting where you think it has the best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers (see
Speaker
Distance
on page 104).
Noise or hum can be heard
even when there is no sound
being input.
• Check that personal computers or other digital components connected to the
same power source are not causing interference.
Can’t select some Input
functions by the
INPUT
SELECTOR
on the front panel
or the
INPUT SELECT
button
on the remote control.
• Check the Input Skip settings in the Input Setup menu.
• Check the HDMI Input assignment in the Input Setup menu then try OFF.
There seems to be a time lag
between the speakers and
the output of the subwoofer.
• See
Automatically conducting optimum sound tuning (Auto MCACC)
on
page 41 to set up your system again using MCACC (this will automatically
compensate for a delay in the subwoofer output).
The maximum volume
available (shown in the front
panel display) is lower than
the
+12dB
maximum.
• Check that the Volume Limit is set to
OFF
(see
Volume Setup
on page 107).
• The channel level setting may be over
0dB
.
Symptom
Remedy
VSX-1020_FLXCN.book 112 ページ ２０１０年４月１５日 木曜日 午後４時１０分
