Additional information
12
114
En
Settings
Symptom
Remedy
The Auto MCACC Setup
continually shows an error.
• The ambient noise level may be too high. Keep the noise level in the room as
low as possible (see also
Problems when using the Auto MCACC Setup
on
page 43). If the noise level cannot be kept low enough, you will have to set up
the surround sound manually (page 101).
• When using only one surround back speaker, connect it to the
SURROUND
BACK L
(Single) terminals.
• To use a 5.1-channel speaker set, use the surround speakers for the surround
channel, not the surround back channel.
• Make sure there are no obstacles between the speakers and the microphone.
• If
Reverse Phase
is displayed, try the following:
– The speaker’s wiring (+ and –) may be inverted. Check the speaker
connections.
– Depending on the type of speakers and their installation conditions,
Reverse
Phase
may be displayed even if the speakers are properly connected. If this
happens, select
GO NEXT
and continue.
– If the speaker is not pointed to the microphone (listening position) or when
using speakers that affect the phase (dipole speakers, reflective speakers, etc.),
it may not be possible to properly identify the polarity.
After using the Auto MCACC
Setup, the speaker size
setting is incorrect.
• There may have been some low frequency noise in the room from an air-
conditioner, motor, etc. Switch off all other appliances in the room and use
Auto MCACC Setup again.
• Depending on a number of factors (bass reproduction capabilities of the
speakers
,
room size, speaker placement, etc.) this may occur in some cases.
Change the speaker setting manually in
Speaker Setting
on page 103, and use
the
ALL (Keep SP System)
option for the
Auto MCACC
menu in
Automatic
MCACC (Expert)
on page 88 if this is a recurring problem.
Can’t adjust the Fine Speaker
Distance setting (page 92)
properly.
• Check that the speakers are all in phase (make sure the positive (
+
) and
negative (
–
) terminals are matched up properly).
The display shows
KEY LOCK
ON
when you try to make
settings.
• With the receiver in standby, press
STANDBY/ON
for about 10 seconds
while holding down
SPEAKERS
to disable the key lock.
Most recent settings have
been erased.
• The power cord was disconnected from the wall while adjusting this setting.
• Settings are only stored if all the zones are turned off. Turn off all the zones
before unplugging the power cord.
The various system settings
are not stored.
• Do not pull out the power cord while conducting the settings. (The settings
will be stored when both the main zone and sub zone turn off. Turn off all zones
before pulling out the power cord.)
VSX-1020_FLXCN.book 114 ページ ２０１０年４月１５日 木曜日 午後４時１０分
