TP-590TXR Quick Start (P/N: 2900-300864QS REV 2)
P/N:
2 9 0 0 - 3 0 0 8 6 4 QS
Rev:
2
Scan for full manual
TP-590TXR Quick Start Guide
This guide helps you install and use your
TP-590TXR
for the first time.
www.kramerav.com/downloads/TP-590TXR
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check w
hat’s in the box
TP-590TXR
HDMI Line Transmitter
4 Rubber feet
1 Bracket set
1 Power supply (48V DC)
1 Quick start guide
Step 2: Get to know your TP-590TXR
#
Feature
Function
1
USB
Connector
Connect to the USB host, (for example, a laptop).
2
POE STATUS
LED
Lights green when power is supplied over the HDBT link.
3
LINK
LED
Lights green when the HDBT link is valid.
4
IN
LED
Lights green when an HDMI active signal device is connected.
5
ON
LED
Lights green when the device receives power.
#
Feature
Function
1
HDMI IN
Connector
Connect to the HDMI source.
2
IR
3.5mm Mini Jack Connector
Connect to an external infrared transmitter or sensor.
3
RS-232
3-pin Terminal Block
Connect to an RS-232 controller, (for example, a PC to control the projector).
4
AUDIO IN
3.5mm Mini Jack
Connect to the stereo, analog audio source.
5
HDBT OUT
RJ-45
Connector
Connect to the HDBT IN RJ-45 connector on the HDBT receiver.
6
SETUP
4-way DIP-switch
Sets the device behavior (see Step 4).
7
CONTROL
RS-232
3-pin
Terminal Block
Connect to the serial controller to control this device.
8
ETHERNET
RJ-45 Connector
Connect to the Ethernet controller to control this device or to a LAN to transfer network traffic.
9
RESET
Switch
Press and hold for 5 seconds to reset the device to factory default settings.
Press and immediately release to power-cycle the device (Reset).
10
PROG
Mini USB Connector
Connect to a PC to perform firmware upgrades.
11
48V DC
Power Connector
Connect to the power supply.
