Kramer TP-590Txr, Quick Start Manual

Page: 3 / 4

Step 5: Connect the power
Connect the 48V DC power supply to TP-590TXR and plug it into the mains electricity.
Safety Instructions
Caution: There are no operator serviceable parts inside the unit.
Warning: Use only the Kramer Electronics power supply that is provided with the unit.
Warning: Disconnect the power and unplug the unit from the wall before installing.
See www.KramerAV.com for updated safety information.
Step 6: Operate TP-590TXR
Operate TP-590TXR via:
•
Remotely, using Protocol 3000
commands via RS-232 or
Ethernet
•
Embedded web pages via the
Ethernet
•
Remotely, using an IR remote
control transmitter
Default Parameters
Parameter Value
Name KRAMER_
Model TP-590TXR
IP Address 192.168.1.39
UDP Port 50000
TCP Port 5000
Network Mask 255.255.0.0
Gateway Address 192.168.0.1
RS-232 Baud Rate 115200
Audio delay input switching on new signal 0 seconds
Audio delay input switching on signal loss (leave 5V on) 5 seconds
Audio delay input switching on cable unplug 0 seconds
Video delay power off 5V on signal loss 15 minutes
HDCP Mode Follow output
Protocol 3000 Commands
Command Description Command Description
# Protocol handshaking LOCK-EDID? Get EDID lock state
AUD-EMB? Get audio in video embedding status LOGIN Set/get protocol permission
AUD-SIGNAL? Get audio input signal status LOGOUT Cancel current permission level
AV-SW-MODE? Get auto switch mode MODEL? Read device model
AV-SW-TIMEOUT Set/get video auto-switch timeout NAME Set/get machine (DNS) name
BUILD-DATE? Read device build date NAME-RST
Reset machine name to factory default
(DNS)
CPEDID Copy EDID data from the output to the input NET-DHCP Set/get DHCP mode
DIR List files in device NET-GATE Set/get gateway IP
DISPLAY? Valid / Invalid output NET-IP Set/get IP address
ETH-PORT Set/get Ethernet port protocol NET-MAC? Get MAC address
FACTORY Resets the device to factory default NET-MASK Set/get subnet mask
FS-FREE? Get file system free space PASS Set/get Password
GEDID Read EDID data PRIORITY? Get priority for all channels
GET Get file PROT-VER? Get device protocol version
HDCP-MOD Set/get HDCP mode RESET Reset device
HDCP-STAT? Get HDCP signal status SECUR Start / Stop Security
HELP
Get command list or help for specific
command SIGNAL? Get input signal lock status
LDEDID Write EDID data to input SN? Read device serial number
LDFW Load new firmware UPGRADE Perform firmware upgrade
LOAD Load new firmware VERSION? Read device firmware version