2
Touch ADJ. next to TIME ALIGNMENT
on the sound setting menu.
#
You cannot adjust the time alignment when
neither
FRONT LEFT
nor
FRONT RIGHT
is se-
lected in the position selector mode.
3
Touch
or
to adjust the distance be-
tween each speaker and the listening posi-
tion.
Each time you touch
or
it increases or de-
creases the distance.
0inch
to
200inch
is dis-
played as the distance is increased or
decreased.
#
You can mute the selected speaker unit by
touching
MUTE
. To cancel muting, touch
MUTE
again.
#
You cannot select speakers whose size is set
at
OFF
.
Note
You can store the adjusted setting in memory by
using
MEMORY
. For details concerning opera-
tion, refer to
Storing the adjusted audio settings in
memory
on page 106.
Adjusting the speaker
output levels
You can adjust the speaker output level of
each speaker unit.
Recalling the speaker output
level settings
%
Touch SPEAKER LEVEL on the sound
setting menu to select the speaker output
level setting.
Touch
SPEAKER LEVEL
repeatedly to switch
between the following speaker output level set-
tings:
CUSTOM1
—
CUSTOM2
—
CUSTOM3
—
AUTO
—
LAST MEMORY
#
You can select
LAST MEMORY
only when the
adjusted speaker output level setting is not mem-
orized in this unit.
#
You cannot select
AUTO
when
NETWORK
has been selected. (Refer to
Switching the DSP
setting mode
on page 117.)
#
When
STANDARD
has been selected, you
cannot select
AUTO
if auto TA and EQ has not
been carried out.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1
Recall the speaker output level settings
you want to adjust.
Refer to
Recalling the speaker output level set-
tings
on this page.
2
Touch ADJ. next to SPEAKER LEVEL on
the sound setting menu and then touch
TEST TONE.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
Front left speaker
—
Front center speaker
—
Front right speaker
—
Rear right speaker
—
Rear
center speaker
—
Rear left speaker
—
Subwoo-
fer
Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the
test tone.
#
Using
TEST TONE
, the tweeters and the front
speakers are adjusted same time. To adjust them
separately, please refer to
Adjusting the speaker
output levels finely
on the next page.
#
The settings do not appear for speakers
whose size is set
OFF
.
Audio Adjustments
En
104
Section
20
