Additional information
13
139
en
Important information regarding the HDMI connection
There are cases where you may not be able to route HDMI signals through this receiver (this depends on the HDMI-
equipped component you are connecting–check with the manufacturer for HDMI compatibility information).
If you aren’t receiving HDMI signals properly through this receiver (from your component), please try one of the
following configurations when connecting up.
Configuration A
Use component video cables to connect the video output
of your HDMI-equipped component to the receiver’s
component video input. The receiver can then convert the
analog component video signal to a digital HDMI signal
for transmission to the display. For this configuration,
use the most convenient connection (digital is
recommended) for sending audio to the receiver. See the
operating instructions for more on audio connections.
Note
• The picture quality will change slightly during
conversion.
Configuration B
Connect your HDMI-equipped component directly to the
display using an HDMI cable. Then use the most
convenient connection (digital is recommended) for
sending audio to the receiver. See the operating
instructions for more on audio connections. Set the
display volume to minimum when using this
configuration.
Note
• If your display only has one HDMI terminal, you can
only receive HDMI video from the connected
component.
• Depending on the component, audio output may be
limited to the number of channels available from the
connected display unit (for example audio output is
reduced to 2 channels for a monitor with stereo audio
limitations).
• If you want to switch the input function, you’ll have to
switch functions on both the receiver and your
display unit.
• Since the sound is muted on the display when using
the HDMI connection, you must adjust the volume on
the display every time you switch input functions.
HOME MEDIA GALLERY
Amp-linked operation not
possible using KURO LINK
function.
• Check the HDMI connections.
• The cable may be damaged.
• Select
ON
for the KURO LINK setting (see
KURO LINK Setup
on page 85).
• Turn the TV’s power on before turning on this receiver’s power.
• Set the TV side KURO LINK setting to
ON
.
• Connect the TV to the
HDMI OUT 1
terminal and set the HDMI output to
HDMI OUT 1
. Then turn
on first the TV’s power, then this receiver’s power.
Symptom
Remedy
Symptoms
Causes
Remedies
Cannot access the network.
The LAN cable is not firmly connected.
Firmly connect the LAN cable (page 72).
The router is not switched on.
Switch on the router.
Internet security software is currently installed in
the connected component.
There are cases where a component with Internet
security software installed cannot be accessed.
The audio component on the network which has
been switched off is switched on.
Switch on the audio component on the network
before switching on this receiver.
Playback does not start while
‘Connecting...’
continues to
be displayed.
The component is currently disconnected from
this receiver or the power supply.
Check whether the component is properly
connected to this receiver or the power supply.
SC-27_25.book Page 139 Monday, April 6, 2009 7:15 PM
