Additional information
13
132
en
Tip
• The distance to the subwoofer may be slightly larger
than the distance actually measured with a tape
measure, etc. This is because this distance is
corrected for electric delay, and is not a problem.
Positional relationship between speakers
and monitor
Position of front speakers and monitor
The front speakers should be as equidistant as possible
to the monitor.
Position of center speaker and monitor
Since mostly dialogs are output from the center speaker,
keeping the center speaker as close as possible to the
screen makes the overall sound more natural. For TVs
using Braun tubes, however, when installing the center
speaker on the floor, adjust its angle of elevation to point
it towards the listening position.
• If the center speaker is not of the shielded type, install
it away from the TV.
• When installing the center speaker on top of the
monitor, place it facing slightly downwards towards
the listening position.
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with
this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other
components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks
listed below, ask your nearest Pioneer authorized independent service company to carry out repair work.
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Power
Monitor
L
R
45° to 60°
Installation on floor
(Diagram as seen
from the side)
Monitor
Symptom
Remedy
The power does not turn on.
• Make sure that the power cord is plugged in to an active power outlet.
• Try disconnecting from the power outlet, then plugging back in.
Power cannot be turned off.
(
ZONE 2
ON
or
ZONE 3
ON
is
displayed.)
• Set the remote control’s
MULTI-ZONE
operation selector switch to
ZONE 2
or
ZONE 3
, then press
RECEIVER
to switch the sub zone off.
The receiver suddenly switches
off or the
PHASE CONTROL
indicator blinks.
• Check that there are no loose strands of speaker wire touching the rear panel or another set of
wires. If so, re-attach the speaker wires, making sure there are no stray strands.
• The receiver may have a serious problem. Disconnect from the power and call a Pioneer authorized
independent service company.
During loud playback the
power suddenly switches off.
• Turn down the volume.
• Lower the 63 Hz and 125 Hz equalizer levels in the
Manual MCACC setup
on page 112.
• Switch on the digital safety feature. While holding down
ENTER
on the front panel, press
STANDBY/ON
to set this receiver to the standby mode. Use
/
to select
D.SAFETY
OFF
,
and then use
/
to select
1
or
2
(select
D.SAFETY
OFF
to deactivate this feature). If the power
switches off even with
2
switched on, turn down the volume. With
1
or
2
on, some features may be
unavailable.
SC-27_25.book Page 132 Monday, April 6, 2009 7:15 PM
