16
Setup
2.
Loosen the coil mounting clamp lever.
3. Note the centerline marks on each end of the coil. Slide and swivel the coil so that the mark on
the entrance end of the coil is positioned outside of
one edge
of the bottle cap. The mark on the
exit end of the coil is to be positioned outside of the
opposite edge
of the bottle cap. In other
words, the centerline of the coil is to sweep across the full width of the bottle cap. See Figure 6
below for additional adjustment instructions.
4. Firmly tighten the coil mounting clamp lever. Make sure that the coil does not swivel during
tightening
.
Figure 6
- Adjusting the Universal Coil
Summary of Contents for UniFoiler 3000
