Pillar UniFoiler 3000, Operator'S Manual

Page: 16 / 39

10
Installation
Connect the power cable to the coil. It is very important that the connector is securely fastened
and properly positioned.
Hand Held Sealing Coil
The hand held coil in intended for low volume production runs and for special packaging needs
which prohibit the use of a conveyor system. This coil is held by the operator, and requires the
activation of a start switch on the handle of the coil to start the sealing process. A capacitor bank
is enclosed within the coil housing.
Note that the hand held coil has a 10-foot cable permanently attached, with a connector on the
other end going to the power supply. Figure 4 on page 8 shows the normal mounting
arrangement.
Connect the power cable from the coil to the connector on the heatsink on the back of the power
supply. It is very important that the connector is securely fastened and properly positioned.