PIAGGIO Beverly 500 i.e., Workshop Manual

Page: 203 / 382

17 - Introduce the return pipe into a graduated
container.
Using the diagnostic tester, start the fuel pump for
10 seconds.
Make sure that the power supply voltage is more
than 12V.
Measure the amount of fuel delivered.
Pump free flow rate = 300 - 320 cc.
YES go to 18 NO go to 19
Specific tooling
020680Y Diagnosis Tool
18 - The fuel filter is not clogged.
The scooter can be used respecting the limit of 48000 km.
19 - The flow rate is less than 250 cc.
The fuel filter is dirty. Replace the pump support.
Pump electrics check
This section describes the operations to be carried out to perform electric checks on the pump.
Resistor check
Disconnect the connector from the pump support.
Using a tester, measure the pump winding resist-
ance.
Connect the tester probes to the pump support
pins as shown in the figure.
Electric characteristic
Resistance:
approx. 1.5
Ω
In case of infinite resistance, replace the pump.
With infinite resistance, the pump does not rotate.
With resistance close to 0
Ω
, the pump power consumption is too high, with the possibility of blowing
the 10 A fuse No. 2. Perform the following check.
Beverly 500 i.e.
Injection
INJEC - 203