User Manual
M110T0032-EN, valid for M-110.xxx1 / M-111.xxx1 / M-112.xxx1
MMa 20. September 2018
Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstrasse 1, 76228 Karlsruhe, Germany
Page 7 / 26
Phone +49 721 4846-0, Fax +49 721 4846-1019, Email
,
www.pi.ws
Mechanical Installation
NOTICE
Protruding screw heads!
Protruding screw heads can damage the positioner.
Make sure that the screws are tightened and recessed completely, and do not interfere
with motion of the platform.
Mounting the Positioner onto a Surface
NOTICE
Warping of the positioner reduces positioning accuracy
Mechanical tension can occur when for example,
•
the positioner is mounted on uneven surfaces (flatness > 10 µm)
•
the positioner and the surface heat up/cool down at different rates
•
the gaps from the mounting holes in the positioner to the surface do not line up
Avoid any mechanical tension.
NOTICE
Unwanted changes in position when mounted vertically or obliquely!
In order for the platform and the setup (payload) to remain at rest when it is switched off, its
weight force component may not exceed the holding force of the drive (10 N) in the
direction of motion.
Lay out the inclination of the surface and the mass of the setup according.
Before startup, check whether the platform moves when the drive is switched off.
INFORMATION
When installing, pay attention to the desired travel range for your payload.
Mounting from above
Tools/accessories
2 mounting screws, DIN 7984 M3x6, in the scope of delivery
Hex key AF 1.5, in the scope of delivery
Hex key AF 2, in the scope of delivery
Surface with holes and M3 thread according to the position of the mounting holes in
the positioner (see fig.); min. depth of
3 mm
.
