PI M-110.*2S1 series, User Manual

Page: 12 / 26

User Manual
M110T0032-EN, valid for M-110.xxx1 / M-111.xxx1 / M-112.xxx1
MMa 20. September 2018
Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstrasse 1, 76228 Karlsruhe, Germany Page 12 / 26
Phone +49 721 4846-0, Fax +49 721 4846-1019, Email info@pi.ws , www.pi.ws
Electrical Installation
INFORMATION
 Positioners with stepper motor have the letter sequence 2S in the model designation and
must be connected to a controller from the C-663.12 series.

Positioners with DC gear motor have the letter sequence
DG
in the model designation and
must be connected to ta controller from the C-863.11, C-863.12 or C-884 series. You will
need the C-815.LDM1 adapter cable for the
C-863.11 or C-884
. This must be ordered
separately.
 The C-815.LDM1 adapter cable may not be used for the above-mentioned positioners with
stepper motor.
 The connecting cable may only be extended once and only with the extension cable (3 m)
supplied or with a cable specifically recommended.
 Only use the controllers and cables recommended by PI!
Connecting the C-663.12, C-863.11, C-863.12 or C-884 Controller
C-663.12 stepper motor controller / C-863.12 DC motor controller
1.
Optionally, if the attached cable is not long enough: Connect the positioner's plug
connector to the socket on extension cable. The UNC nuts must be removed from the
plug (turn the knurled screws counterclockwise) before connecting directly to the
controller.
2.
Connect the positioner's plug or respectively the extension cable to the "Motor" socket
on the controller.
3.
Tighten the screws on all connectors used.