User Manual
M110T0032-EN, valid for M-110.xxx1 / M-111.xxx1 / M-112.xxx1
MMa 20. September 2018
Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstrasse 1, 76228 Karlsruhe, Germany
Page 14 / 26
Phone +49 721 4846-0, Fax +49 721 4846-1019, Email
,
www.pi.ws
Integration into the Control Software and Initial Test
Requirements
The controller has been connected according to the corresponding user manual and
ready for operation (connected to the power adapter/mains supply
and
positioner; see
above).
The
PIMikroMove®
control software has been installed and started according to the
corresponding user manual.
The positioner is
already referenced
according to the user manual for the controller.
Procedure
INFORMATION
Images are schematic; value setting exemplary.
1.
Click the button in the
PIMikroMove®
(
Axes
tab) main window to move the platform to
the left (
|<
) or right (
>|
) end of the travel range.
2.
Check:
−
Does the platform move to the end of the travel range?
−
Does the drive stop at end of travel range?
−
Does the
Target
value change accordingly in the main window of the control
software (see above)?
If this is not the case:
Check the electrical installation (see the section "Electrical Installation“, p.12) and the
settings in the control software (see user manual for the Controller) If the error persists,
contact the customer service department (
)
