Phytec kitCON-161CS, Hardware Manual

Page: 19 / 62

Pinout

PHYTEC Meßtechnik GmbH 1999 L-356e_2
13
3 Pinout
Please note that all module connections are not to exceed their ex-
pressed maximum voltage or current. Maximum input values are in-
dicated in the corresponding controller manuals/data sheets. As dam-
age from improper connections varies according to use and applica-
tion, it is the user’s responsibility to take appropriate safety measures
to ensure that the module connections are protected from overloading
through connected peripherals.
As shown in Figure 6, all relevant controller signals are brought out
to the kitCON-Connector ( X3 ) in the middle of the board. The kit-
CON-161CS/JC/JI is also prepared to accommodate an ICE/connect-
16x (X2). This special connector enables easy emulation of the
processor. The following section provides an overview of the pin
assignment of the kitCON-Connector, while the ICE/connect-16x is
described in section 3.3.. Sections 3.4, 3.5 and 3.6 describe the pinout
of the DB9-connectors P1, P2 and P3, while the additional RS-232-
connector X1 is described in section 3.7. Further signal inputs and
outputs are provided through the connectors PFO and WDI, which are
described in section 3.8. And section 3.9 describes the two-wire
clamp X7.
Figure 6: Position of the connectors
149
101
109
117
125
133
141
1
5
13
21
29
37
45
53
61
69
77
85
93