Phytec kitCON-161CS, Hardware Manual

Page: 17 / 62

Quickstart Instructions

PHYTEC Meßtechnik GmbH 1999 L-356e_2
11
•
Following erasure of the unprotected Flash sectors, the next menu
will automatically appear on the monitor screen of the Host-PC.
Please press <F2> to indicate the name of the hexfiles to be down-
loaded into the Flash (specify the full pathname). To download the
demo program enter ’Pathname\hello161.h86’. Press <Enter> to
start the download.
•
HELLO161 will be automatically started following download. Suc-
cessful execution results in the message ’Hello World !...’ which
appears on the screen of the Host-PC. The program can also be exe-
cuted by pressing the RESET button on the kitCON-161CS/JC/JI
after turning OFF switch 1 of DIP-switch S3 (i.e.: toggling the
kitCON-161CS/JC/JI into execution mode).
•
To leave FLASHT.EXE press <F1>
If any difficulties should occur during start-up, please contact the
PHYTEC Technical Support hotline.
Quickstart Instructions for Flash-programming - Summary
•
Connect the kitCON-161CS/JC/JI to an IBM-PC or a compatible
system using a serial cable (P1 to COM1 or COM2).
•
Turn switch 1 of Dip-Switch S3 ON
•
Verify that jumper JP13 is closed in position 1+2 and 3+4
•
Attach an unregulated power supply with 8 V= to 12 V=/500 mA
to X5 on the kitCON-161CS/JC/JI. Double check the correct
polarity.
•
Press switch <S1> to perform a RESET
•
Start FLASHT.EXE on your Host- PC (flasht [2 (for COM2)])
from the DOS environment
•
Select menu option ’7’
•
Press ’Y’ to confirm ’Erase’
•
Press <F2>
•
Enter ’Pathname\hello161.h86’
•
Press <ENTER>