Phytec kitCON-161CS, Hardware Manual

Page: 13 / 62

Quickstart Instructions

PHYTEC Meßtechnik GmbH 1999 L-356e_2
7
•
Ensure that switch 1 of DIP switch S3 (right of the kitCON-
Connector) is turned ON.
•
Ensure also that jumper JP13 is closed in position 1+2 and 3+4.
•
Attach a power supply to the power-connector X5. An unregu-
lated 8 V= to 12 V=/500 mA power source can be used to supply
the board. Use only a fixed voltage power supply and no power
supply with variable voltage. Double-check the correct polarity of
the socket as shown in Figure 3. If the power supply is attached
correctly the red LED D4 will light up.
•
Push switch S1 to perform a Reset and to start the Bootstrap
Loader on the kitCON-161CS/JC/JI.
•
Invoke the terminal program MON166.EXE on your Host-PC by
entering the following at the DOS prompt:
mon166 [BR (Baudrate)] [COM port number]
Other communication or terminal programs are not suitable for data
transmission to and from the Monitor program on the
kitCON-161CS/JC/JI, as a special transmission protocol is required.
Ensure that only DOS is active at the time of the invocation.
Ensure that the directory in which MON166.EXE is started con-
tains the two files ’boot’ and ’monitor’ for the Controller C161.
•
The Monitor program will automatically load after invoking
MON166.EXE and the green LED D5 will light up. The loading
procedure can be viewed on the monitor screen of the Host-PC.
•
After successfully loading, the Monitor program will automati-
cally start and its ’#’ prompt will appear on the screen of the Host-
PC.