Phytec kitCON-161CS, Hardware Manual

Page: 11 / 62

Quickstart Instructions

PHYTEC Meßtechnik GmbH 1999 L-356e_2
5
2 Quickstart Instructions
This section provides a step-by-step instruction for putting the
kitCON-161CS/JC/JI into operation. Please note that the following
instructions refer to the current versions of the FlashTools and the
Monitor-program from Keil Elektronik GmbH as of the pressing of
this manual.
Generally the Bootstrap Loader allows downloading and starting of
any program suitable for the target controller.
Depending on the terminal-program used, different applications and
tools will be loaded and executed. For instance when executing the
PHYTEC terminal program FLASHT.EXE, routines for programming
the Flash (the so-called FlashTools
1
) will automatically be loaded and
started. This is in contrast to the terminal-program MON166.EXE
from Keil Elektronik GmbH, which downloads a Monitor program
enabling simple debugging of user code.
The following sections provide a step by step description for starting
the kitCON-161CS/JC/JI using the FlashTools as well as for starting
the kitCON-161CS/JC/JI using the Monitor program
2
.
Figure 3: The Power-Plug
1
: Software-tool for on-board Flash-programming, will be automatically loaded if the terminal-
program FLASHT.EXE is used
2
: The Monitor program is only shipped with kitCON boards included in an Infineon Starter Kit
+8..12VDC
GND
500mA
center hole
2,0mm
5,5mm
- +
polatity: