Instruction & Maintenance Manual
Sheet 1.26
Phoenix
‘SPC10e’
Self Propelled Metering Chipping Spreader
03/12
Top side mirrors (LH & RH), located at top of mirror arms,
give a rear view along the side of the machine so that the
area immediately behind the front hopper and back is
visible. Adjust so the top of the rear tyre is visible in the
centre inside of the mirror. This gives a view into the top of
the front spreading hopper of the machine on the inside of
the mirror and a view into and over the rear receiving
hopper folding side on the top inside of the mirror.
Bottom side mirrors (LH & RH), located at bottom of the
mirror arms, give a side view immediately outward of the
front spread hopper and back along the side, including the
extension spreading hopper when out. Adjust so the area
immediately to the side of the machine (side of front
spreading hopper) is visible. Approximately 3 metres
further to the side of the machine and rearward to the
centre of the machine should be visible.
A further sixth mirror is located at the level of the
operator’s platform, front LHS or RHS, attached to its own
arm. It is placed to view the centre spreading feedroller. It
can be adjusted to see about 2/3rds of the feedroller and
the aggregate falling to the road surface. It can be placed
on either side of the cab as desired. This mirror is not
required for safe manoeuvring of the machine. It is however
of the same type as the side mirrors and may be used to
replace them should the need arise.