Phoenix Contact FL BT EPA, User Manual

Page: 21 / 52

Startup and configuration
7900_en_01 PHOENIX CONTACT
21
4 PANU EPA-to-EPA bridge: wait for configuration
Step 1 for establishing a direct connection (PANU-PANU) between
two EPAs. As long as the LED flashes, the module waits for a con-
nection request.
After connection establishment the module accepts IP address
10.0.0.99. Another address can be assigned via DHCP.
C
5 PANU EPA-to-EPA bridge: connection establishment
Step 2 for establishing a direct connection (PANU-PANU) between
two EPAs. The module initializes connection to a module in mode 4
- “Wait”.
After connection establishment the module accepts IP address
10.0.0.100. Another address can be assigned via DHCP.
A+C
6 PANU EPA-to-EPA bridge with PROFINET optimization:
Connection establishment
Step 2 for establishing a direct connection (PANU-PANU) between
two EPAs. The module initializes connection to a module in mode 4
- “Wait”. SafetyBridge transmission requires the settings page of the
web interface to be switched off.
After connection establishment the module accepts IP address
10.0.0.100. Another address can be assigned via DHCP.
B+C
7 PANU Connection to an FL BT EPA MP in access point mode:
Connection establishment
Step 2 for establishing a connection to an “access point” (NAP) in
state “10 - Wait for client”.
After connection establishment the module accepts IP address
10.0.0.100. Another address can be assigned via DHCP.
A+B+C
8 PANU EPA-to-EPA bridge: connection establishment with EDR
Step 2 for establishing a direct connection (PANU-PANU) between
two EPAs. The module initializes connection to a module in mode 4
- “Wait”. This mode allows for higher data rates. However, it is
dependent on a better wireless connection.
After connection establishment the module accepts IP address
10.0.0.100. Another address can be assigned via DHCP.
D
Table 2-1 Permissible LED combinations when starting up via MODE button
Mode Operating
mode
Configuration setting LEDs A B C D