Phoenix Contact FL BT EPA, User Manual, Page: 11 / 52

FL BT EPA MP
7900_en_01 PHOENIX CONTACT
5
This radio transmitter (identify the device by certification number, or model number if Cate-
gory II) has been approved by Industry Canada to operate with the antenna types listed
below with the maximum permissible gain and required antenna impedance for each an-
tenna type indicated. Antenna types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for use with this device.
The device could automatically discontinue transmission in case of absence of information
to transmit, or operational failure. Note that this is not intended to prohibit transmission of
control or signaling information or the use of repetitive codes where required by the techno-
logy.
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncon-
crolled environment. This equipment should be installed and operated with minimum dis-
tance 20cm between radiator & your body.
This module is intended for OEM integrator. The OEM integrator is still responsible for the
IC compliance requirement of the product, which integrates this module.
20cm minimum distance has to be able to be maintained between the antenna and the
users for the host this module is integrated into. Under such configuration, the IC RSS-102
radiation exposure limits set forth for a population/uncontrolled environment can be satis-
fied.
Any changes or modifications not expressly approved by the manufacturer could void the
users authority to operate this equipment.
1.6 Mounting the FL BT EPA (MP)
1.6.1 Mounting the FL BT EPA (MP) on a level surface
Mount the FL BT EPA (MP) on a level mounting surface and secure it with two screws (e.g.,
84-M3 X 35-8.8 cylinder head screws). For the required drill hole spacing, please refer to
Figure 1-2 on page 6.
A minimum distance of 50 cm between modules must be observed when mounting the
FL BT EPA (MP).
Make sure that the antenna is not located directly in front of a metal surface. Otherwise,
the radio characteristics of the antenna may be considerably affected. Observe a
minimum distance of 20 cm between devices and personnel.