Philips DSR5600/00, Manual

Page: 81 / 100

11 Programming the Remote Control for your STB,
TV, Video Recorder, DVD and Tuner – Amplifier.
11.1 Setting up your remote control
By default at power up, for instance at first installation or at battery replacememt, your remote control is preset to control
your satellite receiver as well as most of the Philips audio/video appliances.
If you have other brands of appliances, or if the presets do not control your Philips appliance, please follow the procedure
here below.
Note: some of the functions described in the next pages may not be available or have the same behaviour for all brand of the same
appliances.
1 Press the MODE button to select the type of appliance you want to set up (TV, VCR, DVD or Amp/Tuner).
Pressing the MODE button once will remind you of the MODE you are in through green light indicators: left for STB, middle
for TV, right for VCR, left/middle for DVD, middle/right for Amp/Tuner.
To set the
MODE , press the MODE button several times until the desired mode is signaled by the light(s). The sequence is:
STB->TV->VCR->DVD->Amp/Tuner. At every key press, lights blink to indicate in which MODE you are in.
2 Press digits 1 and 3 simultaneously untill, the lights corresponding the selected mode blinks twice and remain on.
3 Enter the 4 digit code .The lights couver ponding to the selected mode blinks once at each digit entry. You will find a list of
codes at the end of this manual. (If several codes are possible, go through this procedure with the 1st code and try your
remote control. If you are not successful, repeat the procedure with the second code, and so on).
4 If a valid 4-digit code has been entered, the lights will switch off and blink twice. If not, go back to step 1.
Pressing any key other than digit keys and standby button will automatically exit this procedure.
We advice you to fill in the table below to remind your personal remote control settings, this will be helpful the day you have
to replace the remote control batteries (see NOTE 2 below).
Philips Brand Your appliance Your code
factory setting brand / type setting
TV set 0666
Video Recorder 1608
DVD player / Recorder 0566
Amplifier / Tuner 1316 (Philips tuner)
STB (Your Satellite Receiver) 0038 (Device 1)
Volume Control refer to 4.2.2.1
or 4.2.2.2 section)
Important Notes:
1- You need to reset the STB mode to the factory mode.
If you have made a mistake changing the default setting of the STB mode resulting in the impossibility to control your satellite receiver,
then please refer to above description.
2- Battery change.
If the battery change takes more than 1 minute the remote control may return to the “Philips brand factory settings”. Therefore you
shall proceed with a new setting of your remote control, with the help of the table above, for your non Philips branded appliances.
3- All manufacturers are concerned about the constant improvement of their products. Although the RC2585108 is compatible with
most of the equipment of the following list, Philips cannot guarantee its operation with the complete range of products on the market.
English
PROGRAMMING THE REMOTE CONTROL 31