ELECTRICITY
75
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
Regulator/Temperature control
unit/Starter motor relay/CDI unit/Starter
resistor
- Remove the upper RH fairing. See:
Procedure 6. page 21.
- Removal:
• Regulator (1)
• The starter motor relay (2)
• The temperature control unit (3)
• The ignition module (4)
• The starter resistor (5)
Checking the ignition system
Disconnect the ignition unit and take the
measurements on the harness side.
- Between the green wire and the ground: 0
Ω
.
- Between the green/black wire and the ground
(Ignition sensor) : 195
Ω
±20%
.
- Between the yellow/black wire and the earth
(High voltage primary coil) : 0.5
Ω
±20%
.
- Between the black wire and the ground, ignition
on: 12V (Battery voltage).
If the values are correct, replace the ignition
module.
If the values are incorrect, check:
- The harness.
- The ignition switch.
- The kickstand contactor.
- The high voltage coil:
• Primary: 0.5
Ω
±20%
.
• Secondary: 3.7 K
Ω
±20%
.
• Spark plug socket: 5 K
Ω
±20%
. Low voltage
coil:
- The ignition sensor: Between the green/black
wire and the ground: 195
Ω
±20%
.
3
4
1
5
2
Ω
