Page 33 of 88
User Guide
Petwalk Solutions GmbH & Co KG
18.
Insert the 8 M6 x 30 countersunk screws into the housing holes and bolt them to the sockets
of the threaded rods.
19.
Tighten the screws carefully, alternately and circumferential and check constantly, whether
the tunnel plates can move into the grooves.
NOTE!
The frame shall move evenly to the component by tightening the
screws. If you notice any tension, stop immediately and check
whether a tunnel plate or threaded rod is clamped!
20.
Now connect the power adapter to the power supply.
21.
After a few seconds the device will show the time on the display and the door leaf will be
locked.
(
Congratulations!
You have successfully completed the installation process.
You can now use the device as intended.
NOTE!
When installing in masonry with a tunnel length of more
than 30cm, slight condensation can occur under certain
circumstances - this is not a product defect.
Although the petWALK pet door is optimally insulated and is
proper installed within the insulation layer of your wall,
condensed water may occur on the metal fittings due to lack
of ventilation within the tunnel especially if the pet door
was not opened for a while.
